We have moved to https://dokuwiki.librecad.org/
Lots of content was already moved to the new wiki, but there is still work to do. If you want to contribute, please register a new account at https://dokuwiki.librecad.org/
This wiki will be kept for a while to keep search engine results valid. Moved sites may be deleted here in future.
Difference between revisions of "Points"
From LibreCAD wiki
(Put in Category:Tools) |
(rewrote the whole thing) |
||
Line 7: | Line 7: | ||
Click in the drawing area or enter one of the following in the command line: | Click in the drawing area or enter one of the following in the command line: | ||
− | * | + | *3,4 - to create a point at coordinates x=3, y=4. |
− | + | *@3,4 - to create a point located relative to the last point created; this is vector addition (x,y)+(3,4) where x and y are the coordinates of the last point created. | |
− | *50<45 | + | *50<45 - to create a point 50 units from the origin, and rotated 45 degrees around the origin. The positive x axis is at 0 degrees, the positive y axis is at 90 degrees. |
− | *@ | + | *@50<45 - to create a point 50 units away from the last point, and rotated 45 degrees around that point. |
[[Category:Tools]] | [[Category:Tools]] | ||
[[Category:Usage]] | [[Category:Usage]] |
Revision as of 02:42, 29 April 2015
Commands: po, point
Specify location
Click in the drawing area or enter one of the following in the command line:
- 3,4 - to create a point at coordinates x=3, y=4.
- @3,4 - to create a point located relative to the last point created; this is vector addition (x,y)+(3,4) where x and y are the coordinates of the last point created.
- 50<45 - to create a point 50 units from the origin, and rotated 45 degrees around the origin. The positive x axis is at 0 degrees, the positive y axis is at 90 degrees.
- @50<45 - to create a point 50 units away from the last point, and rotated 45 degrees around that point.