We have moved to https://dokuwiki.librecad.org/
Lots of content was already moved to the new wiki, but there is still work to do. If you want to contribute, please register a new account at https://dokuwiki.librecad.org/
This wiki will be kept for a while to keep search engine results valid. Moved sites may be deleted here in future.
The location of the relative zero position is indicated by in the drawing area.
The relative zero position will be set automatically when you create a new point. You can use "Set Relative Zero" to set its location without creating a point. "Lock Relative Zero" will prevent it from automatically changing.
The relative zero position gives the job of vector addition to the program. So if we create a point at 10,20 and want the next point at vector 30,40 from the last point we can use the
@ symbol in the command line and enter
@30,40. The alternative would be doing the math and entering
|After pressing the icon, you can set the relative zero position the same way you would create a point.|
|After pressing the icon, the relative zero position will not change when creating new points.|
There is another command line use case: you want to create a point 50 units from the relative zero and turned 60 degrees around it.
Again we use the
@ symbol and input