We have moved to https://dokuwiki.librecad.org/
Lots of content was already moved to the new wiki, but there is still work to do. If you want to contribute, please register a new account at https://dokuwiki.librecad.org/
This wiki will be kept for a while to keep search engine results valid. Moved sites may be deleted here in future.
Difference between revisions of "Snapping"
From LibreCAD wiki
m (Ravas moved page Snap Tools to Snapping: snap modes aren't really tools) |
|||
| Line 11: | Line 11: | ||
|- | |- | ||
| [[File:Snapendpoint.png|center|64x64px|frame|Snap Endpoints]] | | [[File:Snapendpoint.png|center|64x64px|frame|Snap Endpoints]] | ||
| − | | Snap to the endpoints of a line segment, | + | | Snap to the endpoints of a line segment, the quadrants of a circle or a point. Command: se |
|- | |- | ||
| [[File:Snaponentity.png|center|64x64px|frame|Snap on Entity]] | | [[File:Snaponentity.png|center|64x64px|frame|Snap on Entity]] | ||
Revision as of 18:48, 14 March 2016
| Mode | Info |
|---|---|
 Free Snap |
Allows for the crosshair to move freely while other snap modes are enabled. Commands: os, sf |
 Snap Grid |
Snap to a grid intersection. Command: sg |
 Snap Endpoints |
Snap to the endpoints of a line segment, the quadrants of a circle or a point. Command: se |
 Snap on Entity |
Snap to the path of an entity. Commands: np, sn |
 Snap Center |
Snap to the center of a circle or ellipse. It will also snap to the foci of an ellipse. Command: sc |
 Snap Middle |
Snap to the middle of a path. Enabling this mode displays a "Middle points" input. If you change the value to 2 then you can snap to the trisection points of a line segment. Command: sm |
 Snap Distance |
If you snap to the endpoint of a line segment then activate 'snap distance' and input 50, then it will snap to a point 50 units from the endpoint on the line segment. However, it will also snap to a point that is 50 units from the other endpoint. Command: sd |
 Snap Intersection |
Snap to the intersection of two entities. This does not currently work for polylines. Command: si |
| Action | Tool | Commands |
|---|---|---|
| RestrictNothing | Restrict Nothing | rn |
| RestrictOrthogonal | Restrict Orthogonal | rr |
| RestrictHorizontal | Restrict Horizontal | rh |
| RestrictVertical | Restrict Vertical | rv |
