We have moved to https://dokuwiki.librecad.org/
Lots of content was already moved to the new wiki, but there is still work to do. If you want to contribute, please register a new account at https://dokuwiki.librecad.org/
This wiki will be kept for a while to keep search engine results valid. Moved sites may be deleted here in future.
Define location of points
Enter the location of a point by "Absolute" or "Relative" reference (Cartesian coordinates):
- Absolute (x,y) is the horizontal (x position), vertical (y position) from origin (0,0).
- Relative (@x,y) is the horizontal (x distance), vertical (y distance) from current or selected point.
Length and Angle: (@l<d) is the distance or length (l) and the angle in degrees from zero (d) from the current or selected point (polar coordinates).
|0 (or 360)||is Right|
2 points: Draw a line between two points (x,y) (x,y).
Angle: Draw a line
Horizontal: Draw a line
Vertical: Draw a line
Rectangle: Draw a line
Parallel through point: Draw a line
Parallel: Draw a line
Bisector: Draw a line
Tangent (P,C): Draw a line
Tangent (C,C): Draw a line
Tangent Orthogonal: Draw a line
Orthogonal: Draw a line
Relative Angle: Draw a line
Polygon (Cen,Cor): Draw a line
Polygon (Cen,Tan): Draw a line
Polygon (Cor,Cor): Draw a line
Centre, Point: Draw a circle with a radius defined by specifying the centre (x,y) and a point (x,y) on the circumference.
2 Points: Draw a circle with a diameter defined by specifying two points (x,y) (x,y).
2 Points, Radius: Draw a circle with two points (x,y) (x,y) on the circumference and with a specified radius (length).
3 Points: Draw a circle with the
Centre, Radius: Draw a circle with the
Tangential, 2 Circles, 1 Point: Draw a circle with the
Tangential, 2 Points: Draw a circle with the
Tangential, 2 Circles, Radius: Draw a circle with the
Tangential, 3 Circles: Draw a circle with the
Centre, Point, Angles:
Spline through points:
Ellipse Arc (Axis):
Center, 3 Points:
Delete between two nodes:
Create Equidistant Polylines:
Create Polyline from Existing Segments:
Allows for modifying the common attributes of the selected entities.
Allows for the modification of an entity's properties.