We have moved to https://dokuwiki.librecad.org/
Lots of content was already moved to the new wiki, but there is still work to do. If you want to contribute, please register a new account at https://dokuwiki.librecad.org/
This wiki will be kept for a while to keep search engine results valid. Moved sites may be deleted here in future.
Tools
Line
2 points: Draw a line between two points (x,y) (x,y).
Angle: Draw a line
Bisector: Draw a line
Free: Draw a line
HorVert: Draw a line
Horizontal: Draw a line
Orthogonal: Draw a line
OrthTan: Draw a line
Parallel: Draw a line
ParallelThrough: Draw a line
PolygonCenCor: Draw a line
PolygonCorCor: Draw a line
Rectangle: Draw a line
RelAngle: Draw a line
Tangent1: Draw a line
Tangent2: Draw a line
Vertical: Draw a line
Circle
Centre, Point: Draw a circle with a radius defined by specifying the centre (x,y) and a point (x,y) on the circumference.
2 Points: Draw a circle with a diameter defined by specifying two points (x,y) (x,y).
2 Points, Radius: Draw a circle with two points (x,y) (x,y) on the circumference and with a specified radius (length).